92 PRELIMINARY Spyder 3 CL User's Manual
03-032-20008-03 DALSA
Mnemonic Syntax Parameters
Description
set exposure mode
sem
m
Sets the exposure mode:
2 = Internal SYNC, internal PRIN,
programmable line rate and exposure
time using commands
ssf and set
3 = External SYNC, internal PRIN,
maximum exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN,
programmable exposure time
7 = Internal programmable SYNC,
maximum exposure time. Factory
setting.
8 = Internal SYNC, internal PRIN,
programmable exposure time.
Maximum line rate for exposure time.
set exposure time
set
f
Sets the exposure time. Refer to the
camera help screen (
h command) for
allowable range.
set fpn coeff
sfc
x i
Set the FPN coefficient.
x =pixel number within the range 1 to
sensor pixel count.
i= FPN value within the range 0 to
2047 (12-bit LSB).
set input LUT
sil
t i
Set a single value in a LUT.
t=Tap: 1 or 2.
i=Value within the range -255 to +256.
set lower threshold
slt
i
The pixels below the lower threshold
are checked for and reported in the
end-of-line sequence in a range from
0-
4095.
set prnu coeff
spc
x i
Set the PRNU coefficient.
x=pixel number within the range 1 to
sensor pixel count.
i= PRNU value within the range 0 to
28671.
set readout mode
srm
i
Set the readout mode in order to clear
out dark current charge in the vertical
transfer gates before the sensor is read
out.
0 = Auto.
1 = Dark current clear.
2 = Immediate readout. Does not clear
dark current.
To Next Page
Loading...
Need help?
General