Dalsa Spyder2 - Setting Baud Rate; Setting the Data Mode; Setting the Video Mode

21 Spyder2 User’s Manual
03-032-10091-06 Teledyne DALSA
3.6 Setting Baud Rate
To set the speed of the camera serial communication port, use the command:
Sy n t ax :
sbr i
Sy ntax Elements:
i
Baud rate. A vailable baud rates are: 9600 (Default), 19200,
57600
, and
115200
.
N otes:
• Pow er-on rate is alw ays 9600 baud.
• The rc (r eset camera) command w i l l not reset the camera to
the pow er-on baud rate.
Example:
sbr 57600
3.7 Setting the Data Mode
To select the camera output mode, use the command:
Sy n t ax :
sdm i
Sy ntax Elements:
i
0
8-bit, using port A for single processor configuration
1 10-bit, using ports A and B for single processor configuration
N otes:
• To obtain the current data mode, use the command
gcp
.
Example:
sdm 0
3.8 Setting the Video Mode
The video mode sets whether the camera is running in calibrated or uncalibrated mode,
or if it is generating a test pattern.
To set the video mode, use the command:
Sy n t ax :
svm i
Sy ntax Elements:
i
Video mode to use. A l l ow abl e v alues are:
0 Uncal i brated v i d eo, deactivated v i d eo corr ection
1 Calibrated video, activated video correction
2 Test pattern right
N otes:
• To obtain the current video mode, use the command
gcp
.
Exampl e
svm 1