36 Spyder2 User’s Manual
03-032-10091-06 Teledyne DALSA
Voltage Measurement
The command vv checks the camer a’s input voltage and internal voltages during power-
up. If they are w i thin the proper range, the camera retu r ns OK>. Otherw i se the camera
returns an error message. N ote that the voltage measurement featu r e of the camera
provides only approximate results (typically within 10%). They should not be used to set
the applied voltage to the camera. The purpose of this test is to isolate gross problems
with the supply voltages.
3.19 Rebooting the Camera
The command rc reboots the camera. The camera starts up with the last saved settings.
Prev iousl y sav ed pixel coeffici ents are also restored.
3.20 Setting the Pre-trigger
A pre-trigger may be required for some frame grabbers.
To set the pre-trigger, use the command:
Sy n t ax :
sp i
Sy ntax Elements:
i
Pretrigger value from
to
.
Example:
sp 10
To Next Page
Loading...
