58 Spyder2 User’s Manual
03-032-10091-06 Teledyne DALSA
Error Codes
Code Description Suggested Cause
64 INFO: Calibration may be out-
of-specification (FPN
coefficient clipped)
: several coef fi ci ents w er e clipped
during the ccf command process
128 INFO: Calibration may be out-
of-specification (DO+FPN >
511)
: at least one pi xel -> digital offset +
FPN coeff i cient > 511
256 INFO: Changing analog
settings of calibration mode
,
in calibration mode after
calibration has been done
512 INFO: For better calibration
results, run FPN calibration
first
:
called before
1024 IN FO: Coeffi cient may be
inaccurate. A/ D clipping has
occurred.
Insufficient analog offset or too much gain
for given light.
Monitoring Task Message Codes
Code Description Suggested Cause
1 WA RN IN G: One or mor e
voltages out of specification
At least one of voltages is out of
2 WA RN IN G: Camera
temperature exceed s speci fi ed
limit
Current camera temperatur e exceeds
specification limit
4
WARNING: External SYNC
not detected
Exposur e M ode 3,4,5,6: external SYN C not
8
WARNING: External PRIN not
detected
Exposure M ode 2: external PRIN not
detected
16 WARNING: Analog gain is
ov er / under the specification
Current analog gain setting is out of
32 WA RN IN G: Li ne rate i s set
below 1000 H z
Exposure mode 2: cur r ent line r ate is below
1Khz
B3 Camera Parameter Screen
You can read current camera settings with the gcp comm and. The table below l ists the
settings displayed on the gcp screen w ith sam ple v alues, al ong w i th a descr i pti on of some
of these settings:
GCP Screen Description
Camera Model No.: S2-xx-xxxxx
Camer a model number.
Camera Serial No.: xxxxxxxxx
Camer a serial number .
Sensor Serial No.: xxxxxxxxx
Sensor ser i al number .
Camera Network ID: x
Camer a netw ork i d set w i th the
command.
See the following
section for a
complete command
list.
To Next Page
Loading...
