Device setup
From the home screen, select the device view button to open the
device setup screen with the active «Input» tab.
The device setup screen follows the same layout structure as shown
in the graphic above and is split into the header and the data
section.
Use the tabbed structure of the device setup screen to get direct
access to the subscreens.
6.1 Device name
Select the centered information field button («Edit device name») in
the header of the device setup screen to enter or edit the device
name (maximum length 15 characters).
The input mask which appears allows either lower-case or upper-
case characters by toggling the corresponding button («ABC») on
the bottom left.
To correct wrong entries, tap the erase button ( ) on the bottom
right.
Tap «OK» on the top right to confirm the entry. This closes the input
mask and switches back to the device setup screen.
Tap the back button (
) on the top left to cancel any entries. This
will also take you back to the device setup screen and will keep
the previous entry.
6.2 Input
Input configuration
The «Input» tab offers the complete input management in one
place where you can configure dedicated input settings, such as:
Þ Input monitoring (Mon)
Þ Input gain (Gain)
Þ Fallback
Þ Override
d&b D40 Reference manual 1.5 en 25
To Next Page
Loading...
