Danfoss FC 300 Series

8-81 Bus Error Count
Range: Function:
0 N/A * [0 - 0 N/A] This parameter shows the number of
messages with faults (e.g., CRC fault),
detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 N/A * [0 - 0 N/A] This parameter shows the number of valid
messages addressed to the slave, sent by the
adjustable frequency drive.
8-83 Slave Error Count
Range: Function:
0 N/A * [0 - 0 N/A] This parameter shows the number of error
messages, which could not be executed by
the adjustable frequency drive.
3.10.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range: Function:
100 RPM * [Application
dependant]
Enter the jog speed. This is a fixed
jog speed activated via the serial
port or serial communication bus
option.
8-91 Bus Jog 2 Speed
Range: Function:
200 RPM * [Application
dependant]
Enter the jog speed. This is a fixed
jog speed activated via the serial
port or serial communication bus
option.
Parameter Descriptions FC 300 Programming Guide
3-90 MG.33.MA.22 - VLT
®
is a registered Danfoss trademark
3
3