Danfoss FC 300 Series

Par. 1-10 - Motor Construction AC motor PM Non-salient Motor
Par. 1-01 - Motor Control Principle
U/f mode VVC+ Flux open-loop
Flux closed-
loop
U/f mode
Flux open-
loop
Flux
closed-
loop
Par. 1-50 - Motor Magnet. at 0
speed
- + - - - - -
Par. 1-51 - Min Speed Norm.
Magne. [RPM] (Par. 002 = RPM)
- + - - - - -
Par. 1-52 - Min Speed Norm.
Magne. [Hz] (Par. 002 = Hz)
- + - - - - -
Par. 1-53 - Model Shift Frequency
- - + + - + +
Par. 1-54 - Voltage Reduction in
Fieldweak
- -
+
see 6)
+ - - -
Par. 1-55 - U/F Characteristics U
+ - - - + - -
Par. 1-56 - U/F Characteristics F
+ - - - + - -
Par. 1-58 - Flystart Test Pulses
Current
- + - - - - -
Par. 1-59 - Flystart Test Pulses
Frequency
- + - - - - -
Par. 1-60 - Low Speed Load
Compensation
- + - - - - -
Par. 1-61 - High Speed Load
Compensation
- + - - - - -
Par. 1-62 - Slip Compensation
-
+
see 7)
+ - - - -
Par. 1-63 - Slip Compensation
Time Const.
+
see 8)
+
+
see 8)
-
+
see 8)
+
see 8)
-
Par. 1-64 - Resonance Damping
+ + + - + + -
Par. 1-65 - Resonance Damping
Time Const.
+ + + - + + -
Par. 1-66 - Min. Current at Low
Speed
- - + + - + +
Par. 1-67 - Load Type
- - + - - - -
Par. 1-68 - Minimum Inertia
- - + - - - -
Par. 1-69 - Maximum Inertia
- - + - - - -
Par. 1-71 - Start Delay
+ + + + + + +
Par. 1-72 - Start Function
+ + + + + + +
Par. 1-73 - Flying Start
- + + + - - -
Par. 1-74 - Start Speed [RPM] (Par.
002 = RPM)
- + - - - - -
Par. 1-75 - Start Speed [Hz] (Par.
002 = Hz)
- + - - - - -
Par. 1-76 - Start Current
- + - - - - -
6) Used when par. 103 is constant power
7) Not used when P103 = VT
8) Part of resonance damping
Parameter Lists FC 300 Programming Guide
MG.33.MA.22 - VLT
®
is a registered Danfoss trademark 4-3
4
4