Danfoss FC 51 Series User Manual

5.1.5 0-** Operation/Display
Parameter
Number
Parameter Description Default Value 2 Setup
Change During
Operation
Conversi
on Index
Type
0-03 Regional Settings [0] International 1 set-up FALSE - Uint8
0-04
Operating State at Power-up
(Hand) [1] Forced stop ref=old All set-ups TRUE - Uint8
0-10 Active Set-up [1] Set-up 1 1 set-up TRUE - Uint8
0-11 Edit Set-up [1] Set-up 1 1 set-up TRUE - Uint8
0-12 Link Setups [20] Linked All set-ups FALSE - Uint8
0-31 Custom Readout Min Scale 0 1 set-up TRUE -2 Int32
0-32 Custom Readout Max Scale 0 1 set-up TRUE -2 Int32
0-40 [Hand On] Key on LCP [1] Enabled All set-ups TRUE - Uint8
0-41 [Off / Reset] Key on LCP [1] Enable All All set-ups TRUE - Uint8
0-42 [Auto on] Key on LCP [1] Enabled All set-ups TRUE - Uint8
0-50 LCP Copy [0] No copy 1 set-up FALSE - Uint8
0-51 Set-up Copy [0] No copy 1 set-up FALSE - Uint8
0-60 Main Menu Password 0 1 set-up TRUE 0 Uint16
0-61
Access to Main/Quick menu w/o
Password 0 1 set-up TRUE - Uint8
Table 5.8
Parameter Lists
VLT
®
Micro Drive FC 51 Programming Guide
MG02C602 - VLT
®
is a registered Danfoss trademark 55
5 5

Danfoss FC 51 Series Specifications

General

Enclosure	IP20
Fieldbus communication	CANopen
Input Voltage	200-240V AC, 380-480V AC
Output Frequency	0-400 Hz
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overtemperature
Communication Interfaces	RS-485
Power range	0.25 kW to 7.5 kW