Danfoss FC 51 Series User Manual

3.3 Quick Menu
The Quick Menu gives easy access to the most frequently
used parameters.
1. To enter the Quick Menu, press [Menu] key until
indicator in display is placed above Quick Menu.
2.
Press [
▲
] [
▼
] to select either QM1 or QM2, then
press [OK].
3.
Press [
▲
] [
▼
] to browse through the parameters
in the Quick Menu.
4. Press [OK] to select a parameter.
5.
Press [
▲
] [
▼
] to change the value of a parameter
setting.
6. Press [OK] to accept the change.
7.
To exit, press either [Back] twice to enter Status,
or press [Menu] once to enter Main Menu.
Illustration 3.9 Indicating Quick Menu Mode
3.4 Main Menu
The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [Menu] key until
indicator in display is placed above Main Menu.
2.
Press [
▲
] [
▼
] to browse through the parameter
groups.
3. Press [OK] to select a parameter group.
4.
Press [
▲
] [
▼
] to browse through the parameters
in the specific group.
5. Press [OK] to select the parameter.
6.
Press [
▲
] [
▼
] to set/change the parameter value.
7. Press [OK] to accept the value.
8.
To exit, press either [Back] twice to enter Quick
Menu, or press [Menu] once to enter Status.
Illustration 3.10 Indicating Main Menu Mode
Programming
VLT
®
Micro Drive FC 51 Programming Guide
10 MG02C602 - VLT
®
is a registered Danfoss trademark
3
3

Danfoss FC 51 Series Specifications

General

Enclosure	IP20
Fieldbus communication	CANopen
Input Voltage	200-240V AC, 380-480V AC
Output Frequency	0-400 Hz
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overtemperature
Communication Interfaces	RS-485
Power range	0.25 kW to 7.5 kW