Danfoss FC 51 Series User Manual

ALARM 91, Parameter value is not valid in this mode
Occurs when trying to write an illegal value to a
parameter.
ALARM 92, Parameter value exceeds the min/max limits
Occurs when trying to set a value outside the range.
Parameter can only be changed when the motor is
stopped. Err. A wrong password was entered, occurs when
using a wrong password for changing a password-
protected parameter.
Troubleshooting
VLT
®
Micro Drive FC 51 Programming Guide
68 MG02C602 - VLT
®
is a registered Danfoss trademark
6
6

Danfoss FC 51 Series Specifications

General

Enclosure	IP20
Fieldbus communication	CANopen
Input Voltage	200-240V AC, 380-480V AC
Output Frequency	0-400 Hz
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overtemperature
Communication Interfaces	RS-485
Power range	0.25 kW to 7.5 kW