2 Installation
2.1 Environment and Clearances
Illustration 2.1 Avoid Constant Stream of Water
Illustration 2.2 Avoid Direct Sunlight
Illustration 2.3 Ensure Adequate Air Flow
Illustration 2.4 Ensure Adequate Air Flow
Illustration 2.5 Mount on Non-flammable Surface
Illustration 2.6 Mount Upright on Vertical Surface. Tilt of up to
10 degrees is permitted
Illustration 2.7 Prevent Dust and Ammonia Gases
NOTICE
When planning the installation site, ensure that inverter
product and warning labels remain visible. For details,
refer to 5 Technical Data.
Installation
L00410568-02_02 / Rev. date: 2013-12-10 7
2
To Next Page
Loading...
Need help?
General