•
For Windows XP and older Windows
versions: http://invertername, where
'invertername' is the final 10 digits of
the serial number.
•
For Windows 7 and newer Windows
versions: http://IP address. The IP
address can be found in the display.
It is not possible to use the installation wizard with
Windows 7 and 8.
Find the serial number marked on the product label on the
side of the inverter enclosure. See Illustration 1.2.
1. The web interface logon dialog opens.
2. Type 'admin' in the user and password fields, and
click ‘Log in’.
3. At initial logon the inverter runs a setup wizard.
3.3.3 Setup Wizard
Step 1 of 8: Display language
Select display language.
•
The default language is English.
NOTICE
This selection defines the language in the display, not
the grid code.
Illustration 3.11 Step 1 of 8: Display Language
To change the language setting later, go to [Setup → Setup Details].
Step 2 of 8: Master setting
To set up a master inverter, click on ‘Set as master’.
•
A scan runs to identify inverters in the network.
•
A pop-up window shows the inverters successfully identified.
Click [OK] to confirm that the correct number of inverters has been found.
Initial Setup and Start
L00410568-02_02 / Rev. date: 2013-12-10 21
3
To Next Page
Loading...
Need help?
General