Illustration 3.12 Step 2 of 8: Master Setting
To change this setting later, go to [Inverter level: Setup → Inverter details].
Step 3 of 8: Time and date
Enter:
•
Time in 24-hour format
•
Date
•
Time zone
Accuracy is important, because date and time are used for logging purposes. Adjustment for daylight savings is automatic.
Illustration 3.13 Step 3 of 8: Time and Date
To change these settings later, go to [Inverter level: Setup → Set date and time].
Step 4 of 8: Installed power
For each PV input, enter installed PV power.
The installed PV power values are used to calculate performance ratio. For more information refer to the FLX Series Design
Guide.
Initial Setup and Start
22 L00410568-02_02 / Rev. date: 2013-12-10
3
To Next Page
Loading...
