CAUTION
Incorrect setting can have serious consequences for
production efficiency.
Illustration 3.14 Step 4 of 8: Installed Power
To change the installed power, go to [Inverter level: Setup → Calibration, PV Array].
Step 5 of 8: Country of Installation
Select the setting to match the location of the installation.
CAUTION
Correct selection is essential to comply with local and
national standards.
Illustration 3.15 Step 5 of 8: Country of Installation
Step 6 of 8: Grid code
Select the grid code to match the location of the installation.
Initial Setup and Start
L00410568-02_02 / Rev. date: 2013-12-10 23
3
To Next Page
Loading...
