NOTICE
To use the default language (English) simply press the
[OK] button twice to select and accept.
Illustration 3.3 Master Mode
To enable master mode go to the Inverter details menu
[Setup → Inverter details → Master mode] and set master
mode to Enabled.
Illustration 3.4 Set Time
Set time as prompted by the display. Press [OK] to select
number. Press [
▲
] to scroll up through the numbers. Select
by pressing [OK].
The clock is 24-hour format. The inverter accounts for
daylight saving automatically.
NOTICE
Set the time and date accurately. The inverter uses this
information for logging. If an incorrect time/date is
accidentally set, correct it immediately in the set date
and time menu [Setup → Inverter details → Set date and
time].
Illustration 3.5 Set Date
Set date as prompted by the display. Press [OK] to select.
Press [
▲
] to scroll up through the numbers. Select by
pressing [OK].
Illustration 3.6 Installed PV Power
Enter the amount of installed PV power for each of the PV
inputs. When a group of PV inputs are connected in
Initial Setup and Start
18 L00410568-02_02 / Rev. date: 2013-12-10
3
To Next Page
Loading...
