TP9000
10
GB
PL
GR
ES
GB
If you want to return the unit to RUN, press PROG and hold until
the display returns to the previous RUN mode. Alternatively
leave alone and the unit will automatically return to RUN after
2 minutes.
Your installer will have set your unit to programme 6, 4 or 2 events
per day for Heating, or 1, 2 or 3 events per day for Hot Water. This
will determine the number of events per day that you are able
to programme.
Before beginning programming the unit remember to check that the
correct function is selected i.e. Heating or Hot Water by using the CH/
HW button.
Changing the preset programmes in 7 day mode
a) Press PROG once until the display shows
the fi rst preset time and temperature
b) Use the + and - buttons to adjust the time
(press and hold to adjust in 10 minute increments)
c) Use the Λ and V buttons to adjust the required temperature
(CH only)
d) Press NEXT to move to the next preset time
and/or temperature (Event 2)
e) Once all events for the day have been
programmed, press DAY/HOL to move to the next day
f) Repeat steps b, c, d & e to programme the remaining weeks
events.
g) Press and hold PROG to return to the main screen.
Changing the preset programmes in 5/2 day mode
For Weekdays
a) Press PROG until the fi rst preset time and
temperature
(Event 1 Days MON, TUE, WED, THU, FRI)
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
To Next Page
Loading...
