TP9000
6
GB
PL
GR
ES
GB
1.1 An introduction to your
programmable room thermostat
The TP9000 is a programmable thermostat designed to control both
your Hot Water and Heating.
Depending on the setting value in the Installer Advanced
Programming (option 41) you can have 7-day, 5-2 day or 24 hour
programming. A full explanation of these diff erent methods is
located on page 10-11.
The thermostat can also be set by you to provide two diff erent
programming blocks which can then be assigned to any day of the
week, this is referred to as A/B programme operation.
The Heating side of the TP9000 can be set by your installer to provide
up to 2, 4 or 6 time and temperature settings each day, whereas the
Hot Water can be set to provide 1, 2 or 3 on/off periods each day.
The thermostat also features useful overrides, including a
programmable frost setting.
The TP9000 has some advanced features which the installer will set-
up if they are required. There are also a number of advanced features
which can be set up by you. These advanced settings alter the way
that your thermostat operates, some also aff ect the programming
functions and the user overrides. Please read the User Advanced
Programming instructions before programming the unit (see page
20).
General Operation
The TP9000 has two distinct display modes
- one for Hot Water, one for Central Heating.
The currently selected mode is indicated by
a bar at the bottom of the LCD screen when
in run mode. The right bar is for Heating,
the left bar is for Hot Water.
1.0 Basics
To Next Page
Loading...
