TP9000
12
GB
PL
GR
ES
GB
Changing preset programmes for AB programming
(Installer option 41 must be set to 5-2 day mode)
Press and hold PROG and V for 3 seconds. The display will change
to the fi gure opposite. This will take you into User Advanced
Programming option 1.
Use Λ and V keys to enable or disable the function
(1=enabled, 0=disabled).
Press PROG for 5 seconds until the display returns
to previous RUN mode.
Press PROG once, the display will change to
show the default days assigned to programme
“A” (days MON, TUE, WED, THU, FRI).
Use the + and - keys to scroll forwards or
backwards through the days of the week.
To deselect a day press V, (for example TUE). To
select a day press Λ (for example SUN).
Any deselected days are automatically assigned
to programme “B”.
Programming “A” programme days and events
a) Press PROG until the fi rst preset time and/
or temperature (Event 1 for Programme A)
appears in display.
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE.
d) Press NEXT to move to the next preset time and temperature
(CH only) (Event 2).
e) Repeat steps b, c, & d to programme the remaining events.
To Next Page
Loading...
Need help?
General
