Danfoss Heating
19
GB
PL
GR
ES
GB
whereas in ALLDAY mode, only the fi rst and last events
will run. If set for two events per day for Heating, or one
ON/OFF event for Water then AUTO and ALLDAY modes
are the same. The display will show how many events are
to run:
Indicates that unit is in ALLDAY or AUTO mode with 2
events per day for 1 On/Off for Hot Water.
Indicates that the unit is in AUTO mode with 4 events per
day for heat or 2 ON/OFF for Hot Water.
Indicates that the unit is in AUTO mode with 6 events per
day for heat or 3 for Hot Water.
ON Indicates Hot Water is permanently on (Applies to Hot
Water only)
OFF Indicates permanently off for Hot Water or Thermostat
mode (see 2.5 on page 16) for Heating
The INFO button is used to display information about
either the next programmed event for the currently
selected mode (central Heating or Hot Water) to display
the outdoor temperature (if outdoor sensor is fi tted)
and to show the Service Due Date if set. Below is a more
detailed explanation of operation:
If no outdoor sensor is fi tted:
Pressing the INFO button will display the time of the next
event according to the programmed times. The event
time shown will include any +HRS or BOOST extensions.
If the next event time is shown fl ashing, this represents
an approximate time due to Optimum Start, Delayed
Start or a timed override being active.
If an outdoor sensor is fi tted:
Pressing the INFO button will display the current outdoor
temperature, followed by the lowest and highest outdoor
temperatures in the last 24 hours.
i
To Next Page
Loading...
