Danfoss VLT 6000 Installation Guide

3.2.2. Power Connections
Cabling and Fusing
The power cable connections are situated as shown below. Dimensioning of cable cross section
must be done in accordance with the current ratings and local legislation. See the Operating In-
structions for details.
For protection of the frequency converter the recommended fuses must be used or the unit must
be with built-in fuses. Recommended fuses can be seen in the Operating Instructions. Always
ensure that proper fusing is made according to local regulation.
Illustration 3.28: Compact IP 00 (Chassis), enclosure D1
VLT
®
5000/6000/8000
High Power Installation Guide
3. Installation
MI.90.J2.02 - VLT
®
is a registered Danfoss trademark 25
3

Danfoss VLT 6000 Specifications

General

Category	Controller
Cooling method	Forced air cooling
Enclosure	IP20
Output frequency range	0-500Hz
Protection features	Overvoltage, Undervoltage, Short circuit
Communication options	Profibus
Ambient temperature range	-10°C to +40°C