VLT® 7000 Booster
■ PC software and serial communication
Danfoss offers various options for serial communication.
Using serial communication, it is possible to monitor,
program and control one or several frequency
converters from a centrally located computer.
All VLT 7000 Booster units have a RS 485 port
and the FC protocol as standard.
Using the RS 485 port enables communication, e.g.
with a PC. A Windows
TM
program, called MCT 10,is
available for this purpose. It can be used to monitor,
program and control one or several VLT 7000 Booster
units. For further information, contact Danfoss.
500-566 Serial communication
NB!:
Information on the use of RS-485 serial interface
is not included in this manual.
MG.70.A1.02 - VLT is a registered Danfoss trademark
10
To Next Page
General