VLT® 7000 Booster
Pa
[17]
kPa
[18]
mVS
[19]
PSI
[36]
lb/in
2
[37]
Function:
Selection of unit to be shown on the display.
This unit will be used if Reference [unit] [2] or Feedback
[unit] [3] has been selected in one of the parameters
007-010, as well as in the Display mode.
In Closed loop, the unit is also used as a unit for
Minimum/ Maximum reference and Minimum/Maximum
feedback, as well as Setpoint 1 and Setpoint 2.
Description of choice:
Select the required unit for the reference/feed-
back signal.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.70.A1.02 - VLT is a registered Danfoss trademark
80
To Next Page
Loading...