NB!
Please consult the VLT
®
AQUA Drive Programming Guide, MG.20.OX.YY for detailed information.
0-21 Display Line 1.2 Small
Option: Function:
Select a variable for display in line 1, middle position.
[1662]
*
Analog input 53 The options are the same as those listed for par. 0-20
Display Line 1.1 Small
.
0-22 Display Line 1.3 Small
Option: Function:
Select a variable for display in line 1, right position.
[1614]
*
Motor Current The options are the same as those listed for par. 0-20
Display Line 1.1 Small
.
0-23 Display Line 2 Large
Option: Function:
Select a variable for display in line 2. The options are the same as those listed for par. 0-20
Display Line 1.1
Small
.
[1615]
*
Frequency
0-24 Display Line 3 Large
Option: Function:
[1652]
*
Feedback [Unit] Select a variable for display in line 2. The options are the same as those listed for par. 0-20
Display Line 1.1
Small
.
0-37 Display Text 1
Option: Function:
In this parameter it is possible to write an individual text string for display in the LCP or to be read via serial
communication. If to be displayed permanently select Display Text 1 in par. 0-20, par. 0-21, par. 0-22, par. 0-23
or par. 0-24,
Display Line XXX
. Use the
▲
or
▼
buttons on the LCP to change a character. Use the
◀
and
▶
buttons to move the cursor. When a character is highlighted by the cursor, it can be changed. Use the
▲
or
▼
buttons on the LCP to change a character. A character can be inserted by placing the cursor between two
characters and pressing
▲
or
▼
.
0-38 Display Text 2
Option: Function:
In this parameter it is possible to write an individual text string for display in the LCP or to be read via serial
communication. If to be displayed permanently select Display Text 2 in par. 0-20, par. 0-21, par. 0-22, par. 0-23
or par. 0-24,
Display Line XXX
. Use the
▲
or
▼
buttons on the LCP to change a character. Use the
◀
and
▶
buttons to move the cursor. When a character is highlighted by the cursor, this character can be changed. A
character can be inserted by placing the cursor between two characters and pressing
▲
or
▼
.
0-39 Display Text 3
Option: Function:
In this parameter it is possible to write an individual text string for display in the LCP or to be read via serial
communication. If to be displayed permanently select Display Text 3 in par. 0-20, par. 0-21, par. 0-22, par. 0-23
8. How to programme the frequency converter
VLT
®
AQUA Drive
Operating Instructions
70
MG.20.M4.02 - VLT
®
is a registered Danfoss trademark
8
To Next Page
Loading...
