Danfoss VLT AutomationDrive FC 300 Series - Default Chapter; Table of Contents

Contents
1 Introduction
3
1.1.1 Approvals 3
1.1.2 Symbols 3
1.1.3 Abbreviations 3
1.1.4 Definitions 4
1.1.5 Electrical Wiring - Control Cables 8
2 How to Programme
11
2.1 The Graphical and Numerical Local Control Panels
11
2.1.1 The LCD-Display 12
2.1.3 Display Mode 14
2.1.4 Display Mode - Selection of Read-Outs 14
2.1.5 Parameter Set-Up 15
2.1.6 Quick Menu Key Functions 15
2.1.8 Main Menu Mode 18
2.1.9 Parameter Selection 18
2.1.10 Changing Data 18
2.1.11 Changing a Text Value 19
2.1.12 Changing a Group of Numeric Data Values 19
2.1.13 Infinitely Variable Change of Numeric Data Value 19
2.1.14 Value, Step-by-Step 19
2.1.15 Read-out and Programming of Indexed Parameters 19
2.1.16 Local Control Keys 21
2.1.17 Initialisation to Default Settings 21
3 Parameter Descriptions
23
3.2 Parameters: 0-** Operation and Display
24
3.3 Parameters: 1-** Load and Motor
34
3.4 Parameters: 2-** Brakes
51
3.5 Parameters: 3-** Reference/Ramps
56
3.6 Parameters: 4-** Limits/Warnings
66
3.7 Parameters: 5-** Digital In/Out
71
3.8 Parameters: 6-** Analog In/Out
90
3.9 Parameters: 7-** Controllers
99
3.10 Parameters: 8-** Communications and Options
105
3.11 Parameters: 9-** Profibus
112
3.12 Parameters: 10-** DeviceNet CAN Fieldbus
112
3.13 Parameters: 12-** Ethernet
112
3.14 Parameters: 13-** Smart Logic Control
113
3.15 Parameters: 14-** Special Functions
129
Contents
VLT
®
AutomationDrive Programmming Guide
MG33ME02 - VLT
®
is a registered Danfoss trademark 1