Danfoss VLT AutomationDrive FC 300 Series - 4 Parameter Lists

4 Parameter Lists
Frequency converter series
All = valid for FC 301 and FC 302 series
01 = valid for FC 301 only
02 = valid for FC 302 only
Changes during operation
”TRUE” means that the parameter can be changed while
the frequency converter is in operation and “FALSE” means
that the frequency converter must be stopped before a
change can be made.
4-Set-up
'All set-ups': the parameter can be set individually in each
of the four set-ups, i. e. one single parameter can have
four different data values.
’1 set-up’: data value will be the same in all set-ups.
Data
type
Description Type
2 Integer 8 Int8
3 Integer 16 Int16
4 Integer 32 Int32
5 Unsigned 8 Uint8
6 Unsigned 16 Uint16
7 Unsigned 32 Uint32
9 Visible String VisStr
33 Normalized value 2 bytes N2
35 Bit sequence of 16 boolean variables V2
54 Time difference w/o date TimD
Table 4.1
Parameter Lists
VLT
®
AutomationDrive Programmming Guide
MG33ME02 - VLT
®
is a registered Danfoss trademark 159
4 4