Auto
on
Reset
Hand
on
O
Status
Quick
Menu
Main
Menu
Alarm
Log
Back
Cancel
Info
OK
On
Alarm
Warn.
130BA027.10
Illustration 2.9
Data storage in LCP
1.
Go to 0-50 LCP Copy
2. Press the [OK] key
3. Select “All to LCP”
4. Press the [OK] key
All parameter settings are now stored in the LCP indicated
by the progress bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
Connect the LCP to another frequency converter and copy
the parameter settings to this frequency converter as well.
Data transfer from LCP to frequency converter
1.
Go to 0-50 LCP Copy
2. Press the [OK] key
3. Select “All from LCP”
4. Press the [OK] key
The parameter settings stored in the LCP are now
transferred to the frequency converter indicated by the
progress bar. When 100% is reached, press [OK].
NOTE
Stop the motor before performing this operation.
2.1.3 Display Mode
In normal operation, up to 5 different operating variables
can be indicated continuously in the middle section: 1.1,
1.2, and 1.3 as well as 2 and 3.
2.1.4 Display Mode - Selection of Read-
Outs
It is possible to toggle between three status read-out
screens by pressing the [Status] key.
Operating variables with different formatting are shown in
each status screen - see below.
Table 2.1 shows the measurements you can link to each of
the operating variables. When Options are mounted,
additional measurements are available. Define the links via
0-20 Display Line 1.1 Small, 0-21 Display Line 1.2 Small,
0-22 Display Line 1.3 Small, 0-23 Display Line 2 Large, and
0-24 Display Line 3 Large.
Each readout parameter selected in 0-20 Display Line 1.1
Small to 0-24 Display Line 3 Large has its own scale and
digits after a possible decimal point. By larger numeric
value of a parameter fewer digits are displayed after the
decimal point.
Ex.: Current readout 5.25A; 15.2A 105A.
Operating variable Unit
16-00 Control Word
hex
16-01 Reference [Unit]
[unit]
16-02 Reference [%]
%
16-03 Status Word
hex
16-05 Main Actual Value [%]
%
16-10 Power [kW]
[kW]
16-11 Power [hp]
[HP]
16-12 Motor Voltage
[V]
16-13 Frequency
[Hz]
16-14 Motor Current
[A]
16-16 Torque [Nm]
Nm
16-17 Speed [RPM]
[RPM]
16-18 Motor Thermal
%
16-20 Motor Angle
16-30 DC Link Voltage
V
16-32 Brake Energy /s
kW
16-33 Brake Energy /2 min
kW
16-34 Heatsink Temp.
C
16-35 Inverter Thermal
%
16-36 Inv. Nom. Current
A
16-37 Inv. Max. Current
A
16-38 SL Controller State
16-39 Control Card Temp.
C
16-40 Logging Buffer Full
16-50 External Reference
How to Programme
VLT
®
AutomationDrive Programmming Guide
14 MG33ME02 - VLT
®
is a registered Danfoss trademark
22
To Next Page
Loading...
