Manual initialisation
1. Disconnect from mains and wait until the display
turns off.
2. 2a Press [Status] - [Main Menu] - [OK] at
the same time while power up for LCP
102, Graphical Display
2b Press [Menu] while power up for LCP
101, Numerical Display
3. Release the keys after 5 s.
4. The frequency converter is now programmed
according to default settings.
This procedure initialises all except:
15-00 Operating Hours
15-03 Power Up's
15-04 Over Temp's
15-05 Over Volt's
NOTE
A manual initialisation also resets serial communication, RFI
filter settings (14-50 RFI Filter) and fault log settings.
How to Programme
VLT
®
AutomationDrive Programmming Guide
22 MG33ME02 - VLT
®
is a registered Danfoss trademark
22
To Next Page
Loading...
