Danfoss VLT Micro Drive

Contents
1 Safety
3
1.1.1 High Voltage Warning 3
1.1.2 Safety Instructions 3
1.1.3 Software Version and Approvals 3
1.1.4 General Warning 3
1.1.5 IT Mains 4
1.1.6 Avoid unintended Start 4
1.1.8 Before Commencing Repair Work 4
2 Introduction
5
2.1.1 FC Identification 5
2.1.2 Type Code 6
3 Programming
8
3.1 How to Programme
8
3.1.1 Programming with MCT 10 Set-up Software 8
3.1.2 Programming with the LCP 11 or LCP 12 8
3.2 Status Menu
9
3.3 Quick Menu
10
3.4 Main Menu
10
4 Parameter Descriptions
11
4.1 Parameter Group 0: Operation/Display
11
4.2 Parameter Group 1: Load/Motor
14
4.3 Parameter Group 2: Brakes
19
4.4 Parameter Group 3: Reference/Ramps
21
4.5 Parameter Group 4: Limits/Warnings
25
4.6 Parameter Group 5: Digital In/Out
28
4.7 Parameter Group 6: Analog In/Out
32
4.7.3 6-1* Analog Input 1 32
4.8 Parameter Group 7: Controllers
36
4.9 Parameter Group 8: Communication
37
4.9.6 8-8* Bus communication diagnostics 39
4.10 Parameter Group 13: Smart Logic
40
4.10.1 13-** Programming Features 40
4.11 Parameter Group 14: Special Functions
45
4.12 Parameter Group 15: Drive Information
47
4.12.2 15-4* Drive Identification 47
4.13 Parameter Group 16: Data Readouts
48
Contents
VLT
®
Micro Drive FC 51 Programming Guide
MG02C602 - VLT
®
is a registered Danfoss trademark 1