5.1.6 1-** Load/Motor
Parameter
Number
Parameter Description Default Value 2 Setup
Change During
Operation
Conversi
on Index
Type
1-00 Configuration Mode [0] Speed open loop All set-ups TRUE - Uint8
1-01 Motor Control Principle [1] VVC+ All set-ups FALSE - Uint8
1-03 Torque Characteristics [0] Constant torque All set-ups TRUE - Uint8
1-05 Hand Mode Configuration
[2] As mode 1-00 Configuration
Mode
All set-ups TRUE - Uint8
1-20 Motor Power All set-ups FALSE - Uint8
1-22 Motor Voltage All set-ups FALSE 0 Uint16
1-23 Motor Frequency All set-ups FALSE 0 Uint16
1-24 Motor Current All set-ups FALSE -2 Uint16
1-25 Motor Nominal Speed All set-ups FALSE 0 Uint16
1-29 Automatic Motor Tuning (AMT) [0] Off 1 set-up FALSE - Uint8
1-30 Stator Resistance (Rs) All set-ups FALSE -2 Uint16
1-33 Stator Leakage Reactance (X1) All set-ups FALSE -2 Uint32
1-35 Main Reactance (Xh) All set-ups FALSE -2 Uint32
1-50
Motor Magnetisation at Zero
Speed 100% All set-ups TRUE 0 Uint16
1-52
Min Speed Normal Magnetising
[Hz] 0 Hz All set-ups TRUE -1 Uint16
1-55 U/f Characteristic-U All set-ups TRUE 0 Uint16
1-56 U/f Characteristic-F All set-ups TRUE 0 Uint16
1-60 Low Speed Load Compensation 100% All set-ups TRUE 0 Uint16
1-61 High Speed Load Compensation 100% All set-ups TRUE 0 Uint16
1-62 Slip Compensation 100% All set-ups TRUE 0 Int16
1-63
Slip Compensation Time
Constant 0.1 s All set-ups TRUE -2 Uint16
1-71 Start Delay 0 s All set-ups TRUE -1 Uint8
1-72 Start Function [2] Coast/delay time All set-ups TRUE - Uint8
1-73 Flying Start [0] Disabled All set-ups FALSE - Uint8
1-80 Function at Stop [0] Coast All set-ups TRUE - Uint8
1-82
Min Speed for Function at Stop
[Hz] 0 Hz All set-ups TRUE -1 Uint16
1-90 Motor Thermal Protection [0] No protection All set-ups TRUE - Uint8
1-93 Thermistor Resource [0] None All set-ups FALSE - Uint8
Table 5.9
Parameter Lists
VLT
®
Micro Drive FC 51 Programming Guide
56 MG02C602 - VLT
®
is a registered Danfoss trademark
55
To Next Page
Loading...
Need help?
General