Danfoss VLT Micro Drive Programming Guide

Reference/Ramps................................................................................. 57
Reset................................................................................................... 66, 67
Residual Current Device....................................................................... 4
S
Serial Communication.......................... 9, 24, 30, 37, 38, 39, 48, 49
Set-up Number........................................................................................ 8
Short Circuit............................................................................................ 66
Slip Compensation................................................................. 17, 50, 56
Smart Logic............................................................................................. 60
Special Functions........................................................................... 45, 61
Status Menu.............................................................................................. 9
Symbols...................................................................................................... 7
T
Thermal Load.................................................................................. 15, 48
Thermistor
Thermistor............................................................................ 18, 66, 50
Resource.............................................................................................. 56
Trip Reset................................................................................................. 45
Troubleshooting................................................................................... 63
Type Code String..................................................................................... 5
U
Unit............................................................................................................... 8
V
Value............................................................................................................ 8
Index
VLT
®
Micro Drive FC 51 Programming Guide
70 MG02C602 - VLT
®
is a registered Danfoss trademark

Danfoss VLT Micro Drive Specifications

General

Enclosure	IP20
Input Voltage	200-240V AC
Communication	Modbus RTU
Output Voltage	0-Input Voltage
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Relative Humidity	5-95% (non-condensing)
Altitude	Up to 1000m above sea level