Dantherm HPP-i 8 - 3�10 Installing the Optional Remote; Controller

20
1007332 ISSUE 1
OWNER/INSTALLATION MANUAL
3�10 INSTALLING THE OPTIONAL REMOTE CONTROLLER
This optional accessory replaces e integral controller
and can be installed up to 10m away.
Take e lid off e HPP-i to gain access to e existing
controller. Remove e front cover. Disconnect e plug
from e socket on e back of e controller as shown.
Remove e bulkhead connector from e position
shown and replace it wi a rubber grommet.
This hole
Feed e 10m cable rough e grommet.
Route e cable inside e HPP-i securing it where
necessary.