Dascom DC-8600 - Face Up;Down Stacking for Output Cards; Optimizing Print Quality

Dascom DC-8600 User Guide V1.0
27
2.1.4 Face Up/Down Stacking for Output Cards
User can set up the output cards face up or down.
Auto: Directly ejects the printed cards after printing, no matter the printed surface is faced
up or down.
Face Up: Correctly printed cards are arranged with the printed surface facing up after printing.
Face Down: Correctly printed cards are arranged with the printed surface facing down
after printing.
Follow the below procedures to change the stacking orientation:
 Click “Settings”.
 Click “Basic mode” and then click “Card Setup”.
 Click “Eject Face”.
 Select “front up” or “back up”. Click “Home” to complete the selection.
Auto is the factory default for output cards stacking.
2.1.5 Optimizing Print Quality
For optimizing print quality, you can change the retransfer settings refer to the card you
want to print.
You can select proper card type by LCD panel settings or Windows driver software to
optimize the print quality, which is determined by the retransfer speed/temperature on
various card materials.
Follow the below procedures to change the card type:
 Click “Settings”.
 Click “Basic mode” and then click “Card Setup”.
 Click “Card type”.
 Select the desired card type. Click “Home” to complete the selection.
PVC
PET
PET-G
Card 1（35, 202）
Card 2（20, 207）
Card 3（20, 212）