Dascom DC-8600 - Managing Rejected Cards

Dascom DC-8600 User Guide V1.0
28
2.1.6 Managing Rejected Cards
This printer is equipped with left and right slots to separate correctly printed cards from
rejected ones. By default, rejected cards are ejected from the right slot. However, the two
slots are interchangeable for your preference.
Follow the below procedures to assign the location of the Reject Slot:
 Click “Settings”.
 Click “Basic mode” and then click “Card Setup”.
 Click “Error card exit” or “Std card exit”.
 Select the desired setting. Click “Home” to complete the selection.
For factory defaults, the printer outputs correctly printed cards and rejected ones
to the left and right slots, respectively.