Dascom DC-8600 User Guide V1.0
Probable Cause: Retransfer film winding problem.
Action: Do not turn off power. Refer to Section 2.3 to reload the retransfer film.
Press Right Key to clear this warning and the printer will resume previous
printing after initialization.
Probable Cause: Ribbon winding problem.
Action: Do not turn off power. Refer to Section 2.2 to reload the ribbon. Press
Right Key to clear this warning and the printer will resume previous printing
after initialization.
Pressing SET as LCD display shown may eject jammed card after initialization.
If the fault is not cleared after initialization, turn the rollers manually to clear
jammed card
Pressing SET as LCD display shown may eject jammed card after initialization. If
the fault is not cleared after initialization, turn the rollers manually to clear
jammed card
Do not turn off power. Open the front cover. Turn the rollers to clear jammed
card. Close the front cover. Press Right Key to clear this warning and the printer
will resume previous printing after initialization。
Pressing SET as LCD display. The error may be corrected after initialization
and printing resumes. If initialization cannot clear the fault, manually turn the
rollers to clear jammed card.
Wait for the printer to warm up to its operating temperature.
Check if genuine ribbon is used. Next, check if the ribbon has an RFID ring.
Press Right Key as the LCD shown to initialize the printer.
Contact your reseller’s service support team to report Error Code(s) displayed
on the lower right.
Contact your reseller’s service support team if you find errors not listed
above. Please inform Error Code displayed on the lower right of the LCD.
To Next Page
Loading...
