Chapter 15: Replicator 153
Display Replicator Configuration
State Whether or not replication was started after the initial configuration or the percentage
completed by the initialization process if that process is still in progress.
Replica lag The time difference between the state of the file system on the replica and on the
originator. A generic message of "Less than 5 minutes" appears if the replica is either nearly caught
up with data from the originator or if the replica is caught up and synchronized and the originator is
not sending new data.
Display Replicator Configuration
To display the Replicator role of the current system, the name of the other system in the Replicator
pair, and the state of replication, use the
show config operation. Administrative users only.
replication show config
The display is similar to the following:
# replication show config
Mode: originator
Partner: rep22.yourcompany.com
Enabled: yes
Display Throttle settings
To display all scheduled throttle entries, rates, and the current rate, use the throttle show
operation.
replication throttle show [kb]
The kb option displays the rate in kilobytes per second. Without the option, the rate is displayed in
bits per second. The display is similar to the following:
# replication throttle show kb
Time Sun Mon Tue Wed Thu Fri Sat
---- --- --- --- --- --- --- ---
06:00 - 90 - - - - -
15:00 - - 200 - - - -
18:00 - - 500 - - - -
---- --- --- --- --- --- --- ---
All units in KBps (1024 bytes (8192 bits) per second).
Active schedule: Mon, 06:00 at 90 KBps.
To Next Page