Chapter 5: Configuration Management 53
The Config Command
Reset the Time Zone to the Default
To reset the time zone used by the restorer to the system default of US/Pacific, use the config
reset timezone
command. Administrative users only.
config reset timezone
Set an Administrative Email Address
To give an address to which the restorer sends alerts and autosupport messages, use the config
set admin-email
command. The system needs only one administrative email address. Use the
autosupport and alerts commands to add other email addresses. Administrative users only.
config set admin-email email-address
For example:
# config set admin-email jsmith@company.com
The Admin email is: jsmith@company.com
To check the operation, use the config show admin-email command.
Set an Administrative Host Name
To change the machine from which you can log into the restorer to see system logs and use system
commands, use the
config set admin-host host operation. The host name can be a
simple host name, a host name with a fully-qualified domain name, or an IP address.
Administrative users only.
config set admin-host host
For example, to set the administrative host to admin12.yourcompany.com:
# config set admin-host admin12.yourcompany.com
To check the operation, use the config show admin-host command.
Change the System Location Description
To change the description of a restorer location, use the config set location
“location”
operation. A description of a physical location helps identify the machine when
viewing alerts and autosupport emails. If the description contains one or more spaces, the
description must be in double quotes. Administrative users only.
config set location ”location”
To Next Page
Loading...