Chapter 3: Installation 39
Login and Configuration
c. You can enter a location description for ease of identifying the physical machine. For
example, Bldg4-rack10. The
alerts and autosupport reports display the location.
System Location
Enter a physical location, to better identify this
system[]:
d. Enter the name of a local SMTP (mail) server for restorer emails. If the server is an
Exchange server, be sure that SMTP is enabled.
SMTP Server
Enter the hostname of a mail server to relay email
alerts[]:
e. The default time zone for each restorer is the factory time zone. For a complete list of time
zones, see
“Time Zones” on page 191.
Timezone Name
Enter your timezone name:[US/Pacific]:
f. To allow the restorer to use one or more Network Time Service (NTP) servers, you can
enter IP addresses for NTP servers. The default is to enable NTP and to use multicast.
Configure NTP
Enable Network Time Service? (yes|no)|? [yes]:
Use multicast for NTP? (yes|no|?) [no]:
Enter the NTP Server list (IP addresses) [ ]:
g. A listing of your choices appears. You can accept the settings (Save), reject the settings
and leave the setup process (Abort), or return to the beginning of the current section and
change settings (Retry). A Retry shows your previous choice for each prompt. Press
Return to accept the displayed value or enter a new value.
Pending System Settings
--------------- -----------------
Admin host pls@yourcompany.com
System Location Server Room 52327
SMTP Server mail.yourcompany.com
Timezone name US/Pacific
NTP Servers 123.456.789.33
--------------- --------------------
Do you want to save these settings (Save|Abort|Retry):
To Next Page
Loading...