Installation
48 DD400 Series Restorer User Guide
6. Check that the LUNs available from the connected array system are correct. Use the
down-arrow key, select Show Configuration, and press Enter. The configuration menu appears
with Show Storage Information selected:
System Configuration
(Before Installation)
1. Show Storage Information
2. Show Head Information
3. Go to Previous Menu
4. Go to Rescue Menu
5. Reboot
7. Press Enter to display storage information. Each LUN that is available from the array system
appears as a one line entry in the List of SCSI Disks/LUNs. The Valid RAID DiskGroup UUID
List section shows no disk groups until after installation. Use the arrow keys to move up and
down in the display.
Storage Details
Software Version: 3.1.0.0-19112
Valid RAID DiskGroup UUID List:
ID DiskGroup UUID Last Attached Serialno
------------------------------------------------
-- No diskgroup uuids were found --
List of SCSI Disks/LUNs:
(Press ctrl+m for disk size information)
ID UUID tgt lun loop wwpn comments
---------------------------------------------------------------
1 No UUID 0 0 0 500601603020e212
2 No UUID 0 4 0 500601603020e212
Number of Flash disks: 1
----------------------------------------
Errors Encountered:
----------------------------------------
-- No errors to report
8. Press Enter to return to the New Install menu.
9. Use the up-arrow key to select Do a New Install.
10. Press Enter to start the installation. The system automatically configures the use of all LUNs
available from the array.
To Next Page
Loading...