EasyManuals Logo

DataCard CE870 User Reference Guide

DataCard CE870
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Datacard CE870 User Reference Guide Common LCD Messages
7
6
114: Cover opened during job
Cause: The printer cover was opened while prinng.
1. Check all printer doors to make sure that they are closed completely.
Press down on the cover ridges to make sure that the cover latches completely
on both sides.
2. Make sure that all doors are locked.
3. Press the USER buon to clear the message.
Refer to “Check Data Connecons” on page 23 for more informaon.
125: Emboss critical error
Cause: The embosser has a serious error.
1. Press the POWER buon to power o the system.
2. Request service.
The system must remain powered o.
127: Emboss transport error
Cause: The card is not posioned properly in the embosser.
1. Unlock the embosser.
2. Open the embosser and remove the supply cartridges.
3. Remove any cards found.
4. Replace the cartridges.
5. Close and lock the embosser.
Refer to “Clean the Printer” on page 10 for more informaon.
133: Embosser card reject full
Cause: The embosser reject card tray is full.
1. Unlock and open the embosser.
2. Empty the reject card tray.
3. Close and lock the embosser.
The reject card tray holds ve cards. Empty it regularly.
Refer to “Empty the Reject Card Tray” on page 20 for more informaon.
134: Indent ribbon low
Cause: The indent ribbon is almost at the end of the roll.
Plan to replace the indent ribbon soon.
135: Indent ribbon supplies out
Cause: The indent ribbon has run out.
1. Unlock and open the embosser.
2. Remove the indent ribbon cartridge.
3. Install a new indent ribbon.
4. Replace the cartridge. Close and lock the embosser.
Refer to “Load the Indent Ribbon” on page 14 for more informaon.
136: Indent ribbon break
Cause: The indent ribbon is not moving properly.
1. Unlock and open the embosser.
2. Remove the indent ribbon cartridge.
3. Reposion or repair the indent ribbon. (Replace it, if necessary.)
4. Advance the repaired area one full turn.
5. Replace the cartridge. Close and lock the embosser.
Refer to “Load the Indent Ribbon” on page 14 for more informaon.
140: Embosser not available
Cause: The printer and embosser cannot communicate.
1. Make sure that the data cable between the embosser and the printer is
plugged in securely.
2. Press the POWER buon to power o the printer and embosser.
3. Press the POWER buon again to power on the printer and embosser.

Other manuals for DataCard CE870

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DataCard CE870 and is the answer not in the manual?

DataCard CE870 Specifications

General IconGeneral
BrandDataCard
ModelCE870
CategoryPrinter
LanguageEnglish

Related product manuals