DataCard CE870 User Reference Guide

Datacard CE870 User Reference Guide Load the Indent Ribbon
15
14
Load the Indent Ribbon
1. Unlock and open the embosser supplies door.
2. Remove the indent ribbon cartridge and place it on a at surface with the
spindles facing up.
4. Match the supply spool hub with the le side spindle.
5. Push the supply spool into the spindle unl it clicks securely into place.
IMPORTANT: Do Not Separate
3. Remove the new indent roll from its package.
Cauon: Do not separate the silver take-up spool away from the blue supply
spool.
6. Roll up one full turn of indent ribbon on the silver take-up spool.
7. Roll out a slack length of indent ribbon from the supply spool.
8. Route the ribbon around cartridge rollers. Follow the roung diagram on the
indent cartridge.
Cauon: Do not twist the ribbon while roung.
9. Match the keyed paern of the take-up spool hub with the right side spindle.
10. Push the take-up spool in unl it clicks into place.
11. Turn the take-up spool clockwise one full turn to eliminate slack.
12. Replace the indent ribbon cartridge.
i. Align the cartridge with the guides inside the embosser.
ii. Slide the cartridge in unl it clicks and stops.
13. Close and lock the embosser supplies door.

DataCard CE870 Specifications

General

Brand	DataCard
Model	CE870
Category	Printer
Language	English