Datacard CE870 User Reference Guide Common LCD Messages
9
8
144: Topping foil out
Cause: The topping foil has run out.
1. Unlock and open the embosser.
2. Remove the topping foil cartridge.
3. Install new topping foil.
4. Replace the cartridge. Close and lock the embosser.
Refer to “Load the Topping Foil” on page 16 for more informaon.
147: Topping foil no tag found
Cause: The embosser cannot use the installed topping foil.
1. Unlock and open the embosser.
2. Remove the topping foil cartridge.
3. Install new topping foil.
4. Replace the cartridge. Close and lock the embosser.
Refer to “Load the Topping Foil” on page 16 for more informaon.
150: Print while unlocked
Cause: The printer is unlocked.
The card will be canceled.
Make sure that all access doors are closed and locked securely.
Refer to “Close the Printer Doors” on page 21 for more informaon.
172: Insert cleaning card
Cause: The printer is ready to be cleaned.
• If the cleaning card is in the input hopper, press the USER buon.
OR
• If the cleaning card is not in the input hopper, insert the card into the printer
and then press the USER buon.
Refer to “Clean the Printer” on page 10 for more informaon.
173: Improper shutdown
Cause: The system was shut down improperly or lost power.
1. Press and hold the USER buon to clear the message.
2. Always use the POWER buon to power o the printer.
Refer to “Check Power Connecons” on page 22 and “Check Data Connecons”
on page 23 for more informaon
To Next Page
Loading...
Need help?
General
