Programming
16
GRYPHON™ I GD4200
PROGRAMMING
The reader is factory-configur
ed with a set of standard
default features. After scanning the interface bar code from
the Interfaces section, select other options and customize
your reader through use of the programming bar codes avail-
able in the Gryphon™ I GD4200 PRG. Check the correspond-
ing features section for your interface, and also the Data
Editing and Symbo
logies chapters of the PRG.
Using Programming Bar Codes
This manual contains
bar codes which allow you to reconfig-
ure your reader. Some programming bar code labels, like the
"Reset Default Settings" on page 16, require only the scan of
that single label to enact the change.
Other bar codes require the reader to be placed in Program-
ming Mode prior to scanning them. Scan an ENTER/EXIT bar
code once to enter Programming Mode; scan the desired
parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and
returns the reader
to normal operation.
Configure Other Settings
Additional programming bar codes are available in the
PRG to allow for customizing programming features. If
your installation requires different programming than the
standard factory default settings, refer to the PRG.
Resetting Product Defaults
If you aren’t sure what programming options are in your
reader, or you’ve changed some options and want your cus-
tom factory settings restored, scan the bar code below to
reset the reader to its initial configuration. Reference the PRG
for other options, and a listing of standard factory settings.
Reset Default Settings
NOTE: Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label. See
"Selecting the Interface Type" on page 6 for more
information.
To Next Page
Loading...
Need help?
General
