Selecting the Interface Type
QUICK REFERENCE GUIDE
9
SELECTING THE INTERFACE TYPE
Upon completing the physical connection between the
reader and its host, proceed directly to Interface Selection
below for information and programming for the interface
type supported by the reader and scan the appropriate
bar code to select your system’s correct interface type,
according to your application.
For interfaces other than those listed in this manual, see
the Gryphon™ I GFS4500 Product Reference Guide (PRG),
available online at www.datalogic.com.
RS-232 (GFS4550 ONLY)
Select RS232-STD
RS-232 standard interface
Select RS232-WN
RS-232 Wincor-Nixdorf
Select RS-232 OPOS
RS-232 for use with OPOS/UPOS/JavaPOS
Select USB-COM-STD
a
USB Com to simulate RS-232 standard interface
a. Download the correct USB Com driver from www.datalogic.com
To Next Page
Loading...
