ENTER/EXIT PROGRAMMING MODE DATA FORMAT
90
GRYPHON™ I GD/GBT/GM4200
Case Conversion
This feature allows conversion of the case of all alphabetic characters to upper or lower
case.
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4 character
pairs represented in hexadecimal ASCII values. The first character in the pair is the char
-
acter that will be converted. The second character in the pair is the character to convert
to. If the character to convert in a pair is FF, then no conversion is done. See
"Character
Conversion" on page 238 for more detailed programming instructions.
NOTE: Case conversion affects ONLY scanned bar code data, and does not
affect Label ID, Prefix, Suffix, or other appended data.
$CLFCA00
Case Conversion = Disable (no case conversion)
Case Conversion = Convert to upper case
$CLFCA01
$CLFCA02
Case Conversion = Convert to lower case
Configure Character Conversion
$CLFCH
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0xFFFFFFFFFFFFFFFF
(no character conversion)
To Next Page
Loading...
