ENTER/EXIT PROGRAMMING MODE SYMBOLOGIES
130
GRYPHON™ I GD/GBT/GM4200
GS1 DataBar Expanded Set Length 2
This feature specifies one of the bar code lengths for "GS1 DataBar Expanded Length
Control" on page 129. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Length Mode. Length includes the bar code’s data
characters only.
The length can be set from 1 to 74 characters. A setting of 00 specifies to ignore this
length (only one fixed length). See
"Set Length 2" on page 248 for more detailed pro-
gramming instructions.
Select GS1 DataBar Expanded Set Length 2 Setting
$CXBL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 = 74 (74 characters)
To Next Page
Loading...
