ENTER/EXIT PROGRAMMING MODE WIRELESS FEATURES
260
GRYPHON™ I GD/GBT/GM4500
FEATURES FOR STAR MODELS ONLY
The features in this section are valid only for the Gryphon I GM450X Star model:
• "
STAR Radio Protocol Timeout" on page 260
• "STAR Radio Transmit Mode" on page 261
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the handheld
reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (number of read-
ers in the same area). The selectable range for this feature is from 02 to 25 seconds. See
page 292 in “References” for detailed information and examples for setting this feature.
Set Radio Protocol Timeout
$CSTPT
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Radio Protocol Timeout = 02 (2 seconds)
To Next Page
Loading...
