Datalogic Gryphon I GBT4500 - Symbology-Specific Parameters

CONFIGURATION WITH BAR CODES
34 GRYPHON™ I GD/GBT/GM4500
Symbology-specific parameters:
1D Symbologies, starting on page 118 and 2D Symbologies, starting on page 204 define
options for all symbologies and provides the programming bar codes necessary for con-
figuring these features.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-
gramming page, when applicable.
2. Scan the bar code to set the desired programming feature. You may need to cover
unused bar codes on the page, and possibly the facing page, to ensure that the
reader reads only the bar code you intend to scan.
3. If additional input parameters are needed, go to
Appendix D, and scan the appro-
priate characters from the keypad.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
MING bar code to exit Programming Mode.
For more detailed descriptions, programming information and examples for setting
selected configuration items, see
References, starting on page 265.
NOTE: You must first enable your reader to read bar codes in order to use
this section. If you have not done this, go to
Setup, starting on page 5 and
complete the appropriate procedure.
NOTE: Additional information about many features can be found in the
References, starting on page 265.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.