Datalogic Heron D130 User Manual

RS232 Nixdorf DEFAULT SETTINGS
DATA FORMAT : code identifier enabled, no field adjustment,
code length not transmitted, no header, terminator = CR,
character replacement disabled
RS232 Fujitsu DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 2 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled;
DATA FORMAT : code identifier enabled, no field adjustment,
code length not transmitted, no header, terminator = CR,
character replacement disabled
RS232 ICL DEFAULT SETTINGS
9600 baud, parity even, 8 data bits, 1 stop bit, handshaking
RTS always on, delay disabled, rx timeout 9.9 sec., ack/nack
disabled, FIFO enabled, serial trigger lock disabled;
DATA FORMAT : code identifier enabled, no field adjustment,
code length not transmitted, no header, terminator = CR,
character replacement disabled
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, caps lock auto-recognition
enabled, num lock unchanged, inter-character and inter-
code delays disabled, control character emulation =
ctrl+shift+key;
DATA FORMAT : code identifier disabled, no field adjustment,
code length not transmitted, no header, terminator =
ENTER, character replacement disabled
PEN EMULATION DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output level
normal, idle level normal, minimum output pulse 600 µs,
overflow medium, inter-block delay disabled
POWER SAVE
scan rate max, standby disabled, sleep/USB suspended
disabled
READING PARAMETERS
hardware trigger, trigger active level, no trigger timeout,
Flash On = 1 sec, Flash Off = .6 sec, one read per cycle,
safety time .5 sec, beeper intensity high, tone 2, beeper
type monotone, beeper length short, good read spot
duration medium, stand recognition beep enabled;
automatic operation aiming light enabled
DECODING PARAMETERS
ink spread enabled, overflow control enabled, interdigit
control enabled, Puzzle Solver™ disabled, decoding safety
= one read
USB KEYBOARD NATIONALITY
USB-KBD users should select one of the following KEYBOARD
NATIONALITY codes.
Belge
i'+k
i'+k
i'+k
Deutsch
i'+k
i'+k
i'+k
English
i'+k
i'+k
i'+k
Español
i'+k
i'+k
i'+k
Français
i'+gk
i'+gk
i'+gk
Italiano
i'+bk
i'+bk
i'+bk
Svenskt
i'+k
i'+k
i'+k

Datalogic Heron D130 Specifications

General

Sensor type	CCD
Decoding standards	-2/5. -Code 39 (plus Code 32, Cip 39). -EAN/UPC. -EAN128. -Code 128. -Code 93. -CODABAR. -TELEPEN. -PLESSEY. -Code 49. -Code MSI. -Code Delta IBM. -Code 11. -Code 16K. -ISBN/ISSN. -ISBT128. -GS1 DataBar (RSS).
Cable length	2 m
Standard interfaces	RS-232, USB
Input voltage	5 V
Power consumption	180 mA
Power requirements	5VDC ±5%
Housing material	Polycarbonate (PC)
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	0 - 90 %

Weight and Dimensions

Weight	160 g