Programming
5-172 Magellan
TM
2200VS and 2300HS
GTIN Enable
Enables/Disables the ability to convert UPCE, UPCA, EAN8, and
EAN13 labels into the GTIN 14-character format.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
GTIN = DISABLE
GTIN = ENABLE
NOTE
If add-on information is present on the base label prior to the conversion
taking place, the add-on information will be appended to the converted
GTIN bar code.
To Next Page
Loading...
