Programming
5-24 Magellan
TM
2200VS and 2300HS
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high fre-
quency (controls the beeper’s pitch/tone).
• Low = 660 Hz
• Medium = 866 Hz
• High = 1600 Hz
To set the Good Read Beep Frequency:
1. Scan the SWITCH bar code.
2. Scan your selection from the three bar codes below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
GOOD READ BEEP FREQUENCY = LOW
To Next Page
Loading...
